quizz

In Europe, ITS-G5 is being used for the DSRC (Dedicated Short-Range Communications) technology

1. Starting from which 3GPP release the NR V2X standaridzation has started ?

1. Which V2X Standard defines DSRC ( Dedicated short range communications)

LTE V2X and NR V2X modules can coexist, and can communicate to each other

5G mainly provides the  ———-  of the ITS-G5 architecture

V1, V2, V3, V4 and V5 are the V2X reference points in 5G V2X

The UDM/UDR is the central repository for all subscriber information related to V2X devices

Which 5G V2X reference point exists between the two V2X clients

From which 3GPP release 5G V2X starts supporting 5G MBS (Multicast/Broadcast Service)

In 5G V2X, what is the main V2X Mode used as part of the platooning use case ?

In Infotainement use case what is the key requirement :

What is the best granularity for differentiating QoS differences in the PDU session in 5G ?

Can the SIM card be provisionned using the Policy control Function ?

PQI in V2X for quality of service is related to :

In 5G V2X, which 5QI value is GBR and  can be used for non critical V2X messages

Which  type of ressources type most corresponds to V2X Remote driving use cases :

In 5G V2X, the 5QI values used on the Uu interface are exactly the same used on PQI on the PC5 Interface

In 5G V2X , which signalling protocol is used on the NR-PC5 interface to establish the direct unicat connection

In 5G V2X assuming no GNSS or gNB synchronization is available, a V2X device can utilize its own internal clock

V2X device receives the system information messages SIB 2, to assist in how to configure the side link ?

The PC5 reference point for LTE-V2X has 3 modes of operation, namely: Unicast, Broadcast and Groupcast

The most used communication mode lin 5G V2X is :

The most famous ITS sidelink frequency is :

The 5G PC5 supported bands are  :

The source and destination Layer-2 ID’s are present inside the Direct Link Establishment Request message parameters

RRC reconfiguration sidelink message in PC5 is considered as :

Direct establishment accept message in PC5 is considered as :

if you are using side link synchronisation signal id 0 or 336, it means, you are utilising synchronization to do with :

Sidelink configuration information is included in :

The source and destination layer-2 ID on PC5 is :